Hackabot Nano loaded with many sensors

The following photo could be used as a reference on how to plug in different sensors and breakout boards to Hackabot Nano. (Click to enlarge the picture.)




As mentioned in other posts, power must be unplugged before adding or removing the sensors and breakout boards. Otherwise, it may damage the boards.

In the picture, it shows that the following boards are plugged in:

  • Arduino Nano Compatible Controller
  • WIFI: ESP8266. Default baud rate is usually either 9600 or 115200
  • GPS:┬áneo6mv2
  • Ultrasonic Distance Sensor: HC-SR04
  • Gyroscope: MPU-6050
  • RF module: NRF24L01
  • Magnetometer: HMC5883L